Safety Notes; Installation Instructions; Technical Data; Symbol Description - Hansgrohe 31741180 Instructions De Montage

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• The fittings must be mounted in an insulated manner
and with sound insulation.
Assembly (see page 32)
• Install body with Rp 3/4 outlet pointing downwards.
• Depth of fitting: 68 mm to 96 mm.
• extension set 28 mm
Note: When installation is complete ensure
that the mixer is turned off!
A Direct wall installation.
B Direct wall installation with 10 mm adjustable
mounting studs.
C Brick wall installation.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
Connections Rp 1/2:
• The product is exclusively designed for drinking
water!
4
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 70°C
max. 70°C / 4 min
cold right - hot left
Assembly (see page 32)
English

Symbol description

Do not use silicone containing acetic acid!
Adjustment (see page 33)
To adjust the hot water limiter. Using a hot water limiter
in combination with a continuous flow water heater is
not recommended.
Dimensions (see page 34)
Flow diagram (see page 34)
free flow

Tub outlet

Shower outlet
Spare parts (see page 36)
Special accessories (see page 36)
order as an extra
• extension set 28 mm #32498000
Final assembly (see page 35)
65°C