Schwamborn BEF 320EX Mode D'emploi page 6

BEF 320EX
BEF 320VX
Maintenance
Check the seal strips and
dust protection brushes
and replace if necessary.
Check locking of foot pedal
BEF 320VX:
Check fuel levels of petrol and
motor oil and refill if necessary.
Check and clean air filter and
replace if necessary.
Milling rotor:
Check milling discs and spacers
and replace if necessary
New: Worn out:
Check cutter rods
and replace if necessary
Check bearing bushes
and replace if necessary
6
Maintenance plan
1x/Day 1x/Week
X
X
X
X
X
X
Notes
See
Honda operating manual!
SAE 10W-40 (motor oil 1,1 litres)
Attention:
Danger of injury from sharp edges!
A sharp burr can form on the milling discs during the
milling process. Wear safety gloves!
Injury hazard from heavy machine parts! Do not reach
under the milling rotor when pulling out the milling rotor!
If the free lateral total gap on all cutter rods is greater
than 4 mm per cutter rod, additional spacers need to be
mounted on all cutter rods.
Each cutter rod has to be equipped with the same number
of milling discs and spacers.
Attention:
If the diameter of a cutter rod becomes less than 21 mm,
then all cutter rods need to be renewed.
Attention:
When a bearing bush of the milling rotor has been
knocked out to an oval shape (max. 23 mm), both need to
be replaced.
When a bearing bush of the milling rotor has been ground
through, the milling rotor needs to be replaced.
2021 - 02