Maintenance Plan - Schwamborn BEF 320EX Mode D'emploi

Maintenance plan

Follow the safety instructions and procedure in
the operating manual and in the spare parts plans!
If any defects are found in the machine that could
endanger persons or damage property, stop the
machine immediately and ensure that it cannot be
used again until all repairs are completed.
Before starting cleaning or maintenance work:
- End operation!
- Let machine cool down!
BEF 320EX:
When working on the machine (set-up, maintenance,
service, repair, cleaning, etc.), the power supply of the
machine has to be disconnected from the mains
(disconnect power plug)!
Maintenance
Hydraulic pump:
Check the level of the hydraulic
oil in the oil tank and add more
if necessary.
Electrical components:
Visual check for damages
Check emergency stop and
safety switch.
Machine:
Clean the connection to the
dust extraction and
chassis from milling residues.
Check latch lever for function
Check drive lever for ease of
movement and function
2021 - 02
1x/Day 1x/Week Notes
X
Hydraulic oil SAE 20W-50
- Fluid level: half-full
X
Attention:
Electric shock and risk of fire due to faulty electrical
X
cables! Check the power line and power plug regularly for
functional safety.
X
Attention:
Do not use solvents to clean the machine!
X
X
The operating and maintenance personnel responsible
for the machine must ensure that no one can enter the
machine's danger zone during operation or
maintenance work.
Maintenance work may only be performed by trained
specialists! They must be familiar with the dangers
associated with such work, protect themselves and avoid
danger!
The machine needs to be secured against tipping during
maintenance work!
If necessary, make use of braces.
Keep in mind the weight of the machine and the
machine parts! Secure dismantled parts against falling.
After cleaning and maintenance work, check the safety
equipment for completeness and functionality.
BEF 320EX
BEF 320VX
1/2
5