Petsafe easy walk headcollar licol Guide page 7

Step 1
Attach lead to Control Ring (Fig. A)
Open Neck Strap and hold one end
Step 2
in each hand. Nose Loop and lead
should hang down, like the letter "T." (Fig. B)
Pre-fit Neck Strap high on the neck
Step 3
touching base of skull in back,
with Center Bar Ring in the niche just above
the Adam's apple in front. Center Bar Ring
should be parallel to the neck, not the underside
of jawbone. (Fig. C) Neck Strap must be snug so
that only one finger can squeeze under it,
and it cannot rotate around neck. Gently grasp
skin at back of neck and pull downward toward
shoulders, while at the same time holding Neck
Strap against base of skull – this pulls any excess
skin or coat from under Neck Strap, improving the
fit. Check again to be sure that only one finger
can barely squeeze under Neck Strap, and
tighten if needed. (Fig. D) Notice that even though
the Neck Strap fits much more snugly than other
collars, your dog is comfortable, able to easily
pant and shows no signs of distress. Give him a
treat and see for yourself that he acts as if nothing
is even there! (If using "buckle" style Neck Strap,
mark the appropriate hole for future reference.)
Take Neck Strap off your dog. Slide
Step 4
Adjustable Snap Clamp down to
Control Ring (as in Fig. A). (To open, lift
tab with thumb, dime or key; to close press tab until
it snaps into locked position. The snap is designed
to lock firmly into place and not slip; therefore, it
requires a bit of pressure to open and close.)
Pull Nose Loop up through Center Bar
Step 5
Ring. (Fig. E)
www.premier.com
Fig. A
Fig. B
Fig. C
Fig. D
Fig. E
7