JVC TH-V70 Manuel D'instructions page 16

Getting Started
7 Connecting the satellite (front, center, rear) speakers
Connect the satellite speakers to the powered subwoofer using the supplied speaker cords.
• Connect the white cord to the red (+) terminal and the black cord to the black (–) terminal.
CAUTION:
• When you do not connect the supplied speakers but connect other (larger) speakers, use the speakers with the SPEAKER IMPEDANCE
indicated by the speaker terminals on the rear panel of the subwoofer.
• DO NOT connect more than one speaker to one speaker terminal.
Before connecting the speaker cord
2
1
Fold the end of each
If the speaker cord is
speaker cord to avoid
covered with vinyl,
short-circuit.
remove the vinyl by
twisting it as shown
above.
Front speakers*
(SP-XSV70)
Center speaker (SP-XCV70)
Rear speakers*
(SP-XSV70)
Let the cables
Connect the
pass through the
speaker cords.
groove.
13
Connecting the speaker cord to the satellite speakers
CENTER
SPEAKER
Connecting the speaker cord to the powered subwoofer
1
Groove
Open the terminal
clamp.
* The terminal of SP-XSV70
2
Insert the speaker
cord.
F R O N T S P E A K E R S
CAUTION :
S P E A K E R I M P E D A N C E 4~16
LEFT
RIGHT
CAUTION :
S P E A K E R I M P E D A N C E
4~16
LEFT
RIGHT
CAUTION :
4~16
S P E A K E R I M P E D A N C E
REAR S P E A K E R S
2
Insert the speaker
cord.
1
Press and hold the
terminal clamp.
3
Release the finger from the
terminal clamp.
Powered subwoofer
VOLUME
MAX
MIN
PHASE
REVERSE
NORMAL
SUB WOOFER
C O N N E C T O R
F R O M X V- T H V 7 0
F R O N T S P E A K E R S
CAUTION :
S P E A K E R I M P E D A N C E 4~16
LEFT
RIGHT
CENTER
CAUTION :
SPEAKER S P E A K E R I M P E D A N C E
4~16
LEFT
RIGHT
CAUTION :
S P E A K E R I M P E D A N C E 4~16
REAR S P E A K E R S
3
Close the terminal
clamp.