Muffler; Bevel Gear; Guard - Efco DS 2700 Manuel D'utilisation Et D'entretien

Use only resistor type spark plugs of the
approved range.
Factors such as:
- too much oil in fuel mix;
en
- dirty air filter;
- unfavourable running conditions, e.g.
operating at part load;
may result in rapid deterioration of the spark
plug.

Muffler

WARNING! – This muffler is fitted
with a catalytic converter needed
for the engine to be in compliance
with the emissions requirements.
Never modify or remove the
catalytic converter: failure to do
so is a violation of law.
WARNING! – Mufflers fitted with
catalytic converters get very hot
during use and remain so for
some time after stopping. This
also applies at idle speed. Contact
can result in burns to the skin.
Remember the risk of fire!
CAUTION! - If the muffler is
damaged, it must be replaced. If the
muffler frequently becomes blocked,
this could be an indication that the
efficiency of the catalytic converter
is limited.
WARNING: Do not operate your
brush cutter if the muffler is
damaged, missing or modified.
An
muffler will increase the risk of fire
and hearing loss.
28
MAINTENANCE
improperly maintained

Bevel Gear

Fill with grease using the correct tube to the
level of the lower lip of the access hole (D,
Fig. 8). Do not use more than 0.02 lb (10
grams).
CAUTION: do not use a grease
gun. The high pressure can
damage the bearings and seals.
Use high quality molybdenum bisulphide
grease.
Never use fuel for cleaning operations.

Guard

WARNING: If the cutting tool or
deflector becomes clogged or
stuck, always turn off the engine
and make sure the cutting tool has
stopped before cleaning. Grass,
weeds, etc. should be cleaned
off the cutting tool at regular
intervals.
Replace guard if damaged.