Carburetor Adjustment - Efco DS 2700 Manuel D'utilisation Et D'entretien

• Smaller machines generally require small
trimmer heads and vice versa. This is
because when clearing using a cord the
engine must throw out the cord radially
en
from the trimmer head and overcome the
resistance of the grass being cleared.
• The length of the cord is also important.
A longer cord requires greater engine
power than a shorter cord of the same
diameter.
• Make sure that the cutter on the trimmer
guard is intact. This is used to cut the cord
to the correct length.
• To increase the life of the cord it can be
soaked in water for a couple of days. This
will make the line tougher so that it lasts
longer.
• Only use line of the same diameter as the
original to avoid overloading the engine
(Fig.18).
• In order to get more line out of the cutting
head, tap it lightly on the ground while
working. NOTE: never hit the nylon head
against hard spots such as concrete or
stones, it could be dangerous.
Replacing the nylon line on the LOAD&GO
trimmer head (Fig.19)
1. Cut 28 ft (8.5 m) of nylon line Ø 0.095" (2.4
mm).
2. Align the arrows and insert the line into the
trimmer head (Fig.19.1) until it is released
from the opposite side (Fig.19.2).
3. Divide the line into two equal parts
(Fig.19.3) and then load the trimmer head
by turning the knob (Fig.19.4).
WA R N I N G ! – A l w a y s w e a r
p r o t e c t i v e g l o v e s d u r i n g
maintenance operations. Do not
carry out maintenance with the
engine hot.
26
MAINTENANCE

Carburetor Adjustment

Before adjusting the carburetor, clean
the cover vents and air filter as shown in
Illustration (A, Fig.22), refer to Operation-
Starting Unit and Maintenance-Air Filter
Sections for details. Allow the engine to warm
up prior to carburetor adjustment.
This engine is designed and manufactured
in order to comply with EPA (Environmental
Protection Agency) Phase 3 regulations.
WARNING: Don't try to force the
screws outside the range!
WARNING: Don't modify the
carburetor in any way in such
case the engine will not run
in compliance with emissions
regulations.
Idle Speed Adjustment
• If the engine starts, runs, and accelerates
but will not idle; turn the idle speed screw
"T" clockwise to increase idle speed
(Fig. 20).
• If the cutting attachment turns at idle, turn
the idle speed screw "T" counter-clockwise
to reduce the idle RPM and stop the cutting
attachment movement.
WARNING: If the cutting attachment
still moves at idle speed, contact a
Servicing Dealer for adjustment and
discontinue use until the repair is
made.
WARNING: Weather conditions
and altitude may affect carburation.