DeWalt D55394 Guide D'utilisation page 24

frEE WArnInG lABEl rEPlACEMEnt: If your warning labels
become illegible or are missing, call 1-800-4-D
replacement.
All manuals and user guides at all-guides.com
GLoSSArY
WALT for a free
e
CfM: Cubic feet per minute.
sCfM: Standard cubic feet per minute; a unit of measure of air
PsI: Pounds per square inch; a unit of measure of pressure.
Code Certification: Products that bear one or more of the following
California Code: Unit may comply with California Code 462 (l) (2)/
Cut-In Pressure: While the motor is off, air tank pressure drops
Cut-out Pressure: When an air compressor is turned on and
Branch Circuit: The circuit carrying electricity from electrical panel
Duty Cycle: This air compressor pump is capable of running con-
20
delivery.
marks: UL, CUL, ETL, CETL, have been evaluated by OSHA
certified independent safety laboratories and meet the appli-
cable Underwriters Laboratories Standards for Safety.
(M) (2). Specification/model label is on the side of the air tank
on units that comply with California Code.
when accessory is used. When the tank pressure drops to a
certain low level the motor will restart automatically. The low
pressure at which the motor automatically restarts is called
cut-in pressure.
begins to run, air pressure in the air tank begins to build. It
builds to a certain high pressure before the motor automatically
shuts off, protecting your air tank from pressure higher than
its capacity. The high pressure at which the motor shuts off is
called cut-out pressure.
to outlet.
tinuously. However, to prolong the life of your air compressor,
it is recommended that a 50%-75% average duty cycle be
maintained; that is, the air compressor pump should not run
more than 30-45 minutes in any given hour.