Xiaomi Mi Robot Vacuum-Mop 2 Ultra Manuel D'utilisation page 7

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
Pausing
While the vacuum-mop is running, press any button on the vacuum-mop
to pause it, and then press the button
to resume the cleaning. Pressing
the button
will end the current cleaning task and send the vacuum-
mop back to the charging dock.
Note:
Do not pick up or move the vacuum-mop while it is paused, so as to avoid
navigation errors that could prevent the vacuum-mop from returning to the charging
dock or cause the loss of map.
Sleep Mode
The vacuum-mop will automatically enter sleep mode after it is paused
for 10 minutes, and its indicator will go off. To wake it up, press any button
on the vacuum-mop.
Note:
If the sleep time exceeds 12 hours, the vacuum-mop will be turned off
automatically.
Spot Clean Mode
When the vacuum-mop is in standby mode or paused, press and hold the
button
for 3 seconds to start Spot Clean mode. In this mode, it will
clean a square-shaped area of 1.5 ×1.5 meters directly around the vacuum-
mop. When the spot cleaning is done, the vacuum-mop will automatically
return to its original location and shut off.
11
More App Features
More features are available in the Mi Home/Xiaomi Home app, including
selecting areas to clean, zoned cleanup, the clean there function, and
setting up restricted areas/virtual walls.
Notes:
· Before using these features, the vacuum-mop must complete the first cleaning to create
a map.
· The version of the app might have been updated, please follow the instructions based
on the current app version.
Updating the Firmware
You can update the firmware via the app. Before updating, make sure the
vacuum-mop is on the charging dock and has at least 15% battery left.
Restarting the Vacuum-mop
If the vacuum-mop stops responding or cannot be turned off, press and
hold down the button
for 15 seconds to forcefully turn it off. Then press
and hold the button
for 3 seconds to turn the vacuum-mop on.
Restoring Factory Settings
If the vacuum-mop does not function properly after being restarted, use
a pin to press the reset button until you hear a voice saying "Restoring
factory settings". This will reset the vacuum-mop to its original factory
settings.
Resetting Consumables
Open Mi Home/Xiaomi Home app, select Mi Robot Vacuum-Mop 2
Ultra and then tap " " to open the setting in the top right corner. Select
Consumables and choose the accessory you want to reset, then follow
the instructions in the app to complete the resetting.
12

Publicité

Table des Matières
loading

Table des Matières