Care & Maintenance; Side Brush - Xiaomi Mi Robot Vacuum-Mop 2 Ultra Manuel D'utilisation

Using the Mopping Function
1. First dampen the mop pad and wring out excess water. Next, slide the
edge of the middle part of the mop pad into the middle slot of the water
tank, and then slide the edges on both ends of the mop pad into the slots on
both sides of the water tank. Lastly, press the pad firmly onto the velcro to
attach it to the water tank.
① ② ③
2. Open the water tank lid, fill the tank with water, then securely close the lid.
CAUTION:
· Do not add hot water to the water tank, as this may cause the tank to become deformed.
· To avoid clogging, do not add any cleaning agents or disinfectants to the water tank.
13
3. To install the mopping assembly, slide it into the back of the vacuum-
mop until it clicks into place. Press the button or use the Mi Home/
Xiaomi Home app to start the cleanup. The vacuum-mop will automatically
recognize the mopping assembly and begin mopping and dispensing water
as needed.
CAUTION:
· To prevent the vacuum-mop from entering a carpeted area, use physical barriers or set
up virtual walls or restricted areas in the app before mopping.
· The mop pad should be cleaned after every 30 minutes of use to ensure adequate water
④ flow and cleaning effectiveness.
4. Remove the mopping assembly
After the vacuum-mop finishes cleaning and returns to the charging dock, press
the side clips of the mopping assembly inward and pull to remove the assembly.
Note:
When the vacuum-mop is charging or not in use, remove the mopping assembly. Pour out
all remaining water in the tank, and clean the mop pad to prevent mildew or lingering odors.
Care & Maintenance
Brush
* Weekly cleaning is recommended.
1. Flip the vacuum-mop over and pinch the clips to remove the brush cover.
2. Lift the brush out of the vacuum-mop, then clean the brush bearings.
3. Use the included cleaning tool to cut any tangled hairs on the brush,
and remove the hairs and other debris from the brush.
4. Reinstall the brush and the brush cover, and ensure they are securely in
place.
Note: It is recommended to clean the brush weekly and replaced every 6 to 12 months.
Brush Cover
Clips
Brush
Brush Bearings
Cleaning Tool
CAUTION: If too much hair is tangled in the brush, or if the hair is tightly tangled, do not
forcibly pull on it, as this could damage the brush.

Side Brush

* Monthly cleaning is recommended.
1. Flip the vacuum-mop over and remove the side brush upwards to clean it.
2. Reinstall the side brush to the vacuum-mop.
Note: It is recommended to clean the side brush monthly and replace every 3 to 6 months.
Omnidirectional Wheel
* Clean it as needed.
1. Flip the vacuum-mop over and pull
Wheel
out the omnidirectional wheel.
Axle
2. Remove hair, dirt, and other debris
from the wheel and axle.
3. Reinsert the wheel and press it firmly
back into place.
Notes:
· A small screwdriver or other pry tool can be used to gently pop out and remove the
wheel.
· The wheel can be cleaned with water and reinstalled after drying.
14