Electrolux ESL 7220RO Notice D'utilisation page 27

How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
until the indicators
,
2. Press
.
• The indicators
go off.
• The indicator
flash.
• The end indicator starts to flash.
The number of flashes indicates
the level.
– E.g. 5 flashes + pause + 5
flashes = level 5.
3. Press again and again to
change the setting. Each time you
press the level number
increases. After level 10 you will start
again from level 1.
4. Press the on/off button to confirm the
setting.
6.3 The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
You can set the released quantity of rinse
aid between level 1 (minimum quantity)
and level 6 (maximum quantity). Level 0
will deactivate the rinse aid dispenser and
no rinse aid will be released.
Factory setting: level 4.
How to set the rinse aid level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
and
,
and start to flash.
, and
continues to
and
until the indicators
,
2. Press .
• The indicators
and go off.
• The indicator
• The end indicator starts to flash.
The number of flashes indicates
the current setting: e.g. 4 flashes +
pause + 4 flashes = level 4.
– The levels of rinse aid are from
0 to 6.
– Level 0 = no rinse aid is
released. In this case the end
indicator remains off.
3. Press
again and again to change
the setting. Each time you press
the level increases. After level 6 you go
to level 0 and then start again from
level 1.
4. Press the on/off button to confirm the
setting.
6.4 Use of rinse aid and multi-
tablets
When you activate the option Multitab, the
rinse aid dispenser continues to release
rinse aid. However you can deactivate the
rinse aid dispenser. In this case the drying
results may not be satisfactory.
With the rinse aid dispenser deactivated,
the rinse aid indicator is always off.
How to deactivate the rinse aid
dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
until the indicators
,
2. Press
• The indicators
go off.
• The indicator
to flash.
ENGLISH
,
and start to flash.
,
continues to flash.
and
,
and start to flash.
.
, and
continues
27