Mitsubishi Electric CITY MULTI PLFY-P32VBM-E Manuel D'utilisation page 17

9. Care and cleaning
9.1. Cleaning the filters and the indoor unit
Caution:
• Ask authorized people to clean the filter.
Cleaning the filters
• Clean the filters using a vacuum cleaner. If you do not have a vacuum
cleaner, tap the filters against a solid object to knock off dirt and dust.
• If the filters are especially dirty, wash them in lukewarm water. Take
care to rinse off any detergent thoroughly and allow the filters to dry
completely before putting them back into the unit.
Caution:
• Do not dry the filters in direct sunlight or by using a heat source,
such as an electric heater: this may warp them.
• Do not wash the filters in hot water (above 50°C), as this may
warp them.
• Make sure that the air filters are always installed. Operating the
unit without air filters can cause malfunction.
Caution:
• Before you start cleaning, stop operation and turn OFF the power
supply.
• Indoor units are equipped with filters to remove the dust of sucked-
in air. Clean the filters using the methods shown in the following
sketches.
Filter removal
Caution:
• In removing the filter, precautions must be taken to protect your
eyes from dust. Also, if you have to climb up on a stool to do the
job, be careful not to fall.
• When the filter is removed, do not touch the metallic parts inside
the indoor unit, otherwise injury may result.
PLFY-P . VBM-E Series
Pull the knob on the intake grille in the direction indicated by the ar-
row and it should open.
Open the intake grille.
Release the knob on the center edge of the intake grille and pull the
filter forward to remove the filter .
Knob Grille Intake Grille Filter
17