Table des Matières
Publicité
c) How to use the table stand and wall-mounting
The base unit has a removable table stand.
To attach the table stand, first insert the hook into the corresponding hole on
the rear of the base unit (1) and tilt the stand down (2) until it is engaged.
To detach it, proceed in reverse order.
To mount the base unit on a wall, hang it on a screw head using the
corresponding mounting hole on the back of the unit.
The remote sensor is equipped with a metal bracket which allows for placement
on a surface. Attach it to the corresponding hole on the back of the unit, see
figure below.
To mount the remote sensor on a wall, hang it on a screw head using the
corresponding mounting hole on the back of the unit.
44
All manuals and user guides at all-guides.com
1
2
9. Operation
a) General information
• The "RESET" button on the base unit should only be used in cases where
the unit is malfunctioning (odd icons appear on the LC display). This can
happen, for example, while inserting the batteries.
Carefully press and hold down the "RESET" button for one or two seconds,
using a pointed object (for example a ball-point pen).
• Once batteries have been inserted into the remote sensors, they start
transmitting temperature readings at 30-second intervals.
• The base unit will start searching for the remote sensor signals about one
minute after the batteries have been installed.
Upon successful signal reception, corresponding temperature data will be
displayed on the top line. The indoor temperature (sensor is integrated into
the base unit) will be displayed on the second line.
The base unit will automatically update its readings every 30 seconds.
• If no signals are received for a longer period of time, blanks ("- - - -") will be
displayed and the reception icon will show "
Press the "CH" and "MEM" buttons at the same time to trigger a further
signal search. This function is very useful to synchronize the transmission
and reception between remote sensors and base unit.
b) Switching between time/date display modes
Briefly pressing the "MODE" button several times will toggle the bottom display
line between the clock, clock with weekday and clock with time zone.
".
45
Publicité
Table des Matières
