Conrad Electronic RMR 233 Mode D'emploi page 42

A LED
Briefly flashes when the unit transmits data
B Hole for wall-mounting
For wall-mounting of the remote sensor
C Reset button
To return the remote sensor to factory default settings
D Switch for channel selection
To set a channel of the remote sensor (channel 1, 2, 3)
E Battery compartment
Battery compartment for two (AAA) micro batteries
F Battery compartment cover
To close the battery compartment, secured with 3 screws
G Stand
To place the remote sensor on a surface
40
All manuals and user guides at all-guides.com
h) Manual time/date setting
If reception problems occur, switch off DCF reception first (press
and hold the " " button for 2 seconds until the DCF icon
disappears).
To manually set the time/date, proceed as follows:
• Press and hold the "MODE" button for three seconds. In the bottom right
display corner a digit starts flashing; this is a time zone adjustment.
• To change the setting, press the " " button or the " " button, respectively.
If you choose any other value than "0" (+9 to -9 is possible, see time zone
table on page 29), the time indication will be changed then. The value set,
will be added up to the time set/received (subtracted, respectively).
A quick setting can be done holding down the " " or " " buttons
for a longer period.
If you do not want to change a setting, briefly press the "MODE"
button to skip to another setting.
If you do not press any button for a minute, the last setting will be
stored and the setting mode will automatically be exited.
• Confirm the entry by briefly pressing the "MODE" button.
• The indicator for hour format starts flashing. Press the " " or " " button to
select between 24-hour or 12-hour time format.
• Confirm the entry by briefly pressing the "MODE" button.
• The hour indicator is flashing. Press the " " or " " buttons to set the
desired hour.
• Confirm the entry by briefly pressing the "MODE" button.
• The minute indicator is flashing. Pressing the " " or " " buttons will set the
desired minute.
• Confirm the entry by briefly pressing the "MODE" button.
• The year indicator is flashing. Pressing the " " or " " buttons will set the
desired year.
49