Conrad Electronic RMR 233 Mode D'emploi page 41

A LC display
Displays the temperature measured by the remote sensor as well as
indoor temperature and time (or date)
B Receiving status
Status indicator of the DCF reception
C "MODE" button
To switch between display modes or for entry confirmation
D "CH" button
To switch between remote sensors
E " " button
To decrease the value of a setting
F " " button
To increase the value of a setting
G " " button
To activate the alarm time setting
H Reset button
To return the base unit to factory default settings
I Hole for wall-mounting
For wall-mounting of the base unit
J "MEM" button
Display/Reset of maximum/minimum temperature readings in storage
K Table stand
To place the unit on a surface
L Battery compartment
Battery compartment for two (AAA) micro batteries
38
All manuals and user guides at all-guides.com
i) Alarm setting
The base unit has two different alarm types:
• Single alarm
The alarm is active at the selected time only once, after that, it will
automatically be switched off.
• Weekday alarm
The pre-set alarm will only be activated from Monday to Friday. It will
automatically be deactivated during the weekend (Saturday & Sunday).
To activate the alarm, proceed as follows:
• Press the " " button once to activate the weekday alarm ("
to activate the single (" ") alarm.
Depending on the alarm chosen, a corresponding alarm icon will
be displayed indicating that the alarm has been activated.
• Press and hold the " " button for 3 seconds. The hour digits of the alarm
time start flashing.
• By pressing the " " or " " buttons the hours can be set.
A quick setting can be done holding down the " " or " " buttons
for an extended period of time.
If you do not press any button for a minute, the last setting will be
stored and the alarm time setting mode will automatically be exited.
• Briefly press the " " button. The minute digits of the alarm time start
flashing.
• Pressing the " " or " " buttons will set the desired minutes.
• Briefly press the " " button. The pre-set alarm time will be stored and
the unit returns to the normal clock display.
"); or twice
51