Table des Matières
Publicité
a) Inserting batteries into the remote sensor
• Remove the three screws from the battery compartment cover by using an
appropriate screwdriver.
• Select the desired channel number by using the slide switch "CHANNEL".
Each remote sensor must have a different channel number!
• Insert two (AAA) micro batteries according to the correct polarity. The
respective figure in the battery compartment will help you to do this, see
also figure below.
• Attach the battery compartment cover to the unit and carefully tighten the
screws.
Please note:
The unit can only recognize a channel number change of the
remote sensor, if you have removed the batteries or pressed the
"RESET" button on the remote sensor.
1
42
All manuals and user guides at all-guides.com
2
e) Receiving status for remote sensor
The receiving status which appears on the LC display informs you of the proper
radio reception of the temperature measured by the remote sensor.
The base unit is in searching mode
Perfect radio reception
No reception
f) Display/Clear maximum/minimum values
The maximum and minimum values for the indoor temperature and remote
sensors will be stored automatically. If you wish to have them displayed,
proceed as follows:
1. If required, select first the channel whose maximum/minimum temperature
readings you want to be displayed by pressing the "CH" button.
2. Briefly press the "MEM" button on the rear of the base unit. The maximum
temperature, measured by the remote sensor is displayed on the upper
display line and the maximum temperature, measured by the sensor,
integrated into the base unit, is displayed on the middle line of the unit. In
addition, "MAX" will appear on the display.
3. Briefly pressing the "MEM" button one more time will display the minimum
temperature measured by the remote sensor and the built-in sensor. "MIN"
will appear on the display.
4. Pressing the "MEM" button again will return the unit to the normal display.
To clear the memory, hold down the "MEM" button for two
seconds. You will hear a signal indicating that the maximum/
minimum temperature readings are cleared now.
3
If you press the "MEM" button, the readings displayed will
correspond to the current temperature readings until different
values are measured by the unit.
47
Publicité
Table des Matières
