Assembly Instructions - Christopeit Sport WP 1500 Notice De Montage Et D'utilisation

GB

ASSEMBLY INSTRUCTIONS

Remove all the separate parts from the packaging,
lay them on the floor and check roughly that all are
there on the base of the assembly steps. Please note
that a number of parts are connected directly to the
main frame preassembled. In addition, there are sev-
eral other individual parts that have been attached to
separate units. This will makes assembly easier and
quicker for you. Assembly time: 15 min.
STEP 1:
Attach the rear foot (75) at slide rail (69).
1. Put the rear foot (75) under the seat rail (69) and
screw it tightly by using screw M8x16 (77), washers
8//19 (51) and spring washers for M8 (78).
STEP 2:
Attach the seat rail (69) at frame (52).
1. Put the seat rail (69) onto the holder at frame
(52) sothat the side holes are align and tighten the
side rail (69) at frame (52) by using screw M10x125
(65), washer 10//20 (66) and nylon nut M10 (67).
Don't tighten the screw (65) too much, sothat the
fold up system works easy.
2. Secure the seat rail (69) before training by screw
in the hand grip screw (68), washer (103) and lock up
with locking pin (70).
STEP 3:
Attach the computer (1) at computer support (2).
1. Take the computer (1) and insert the batteries
(Type "AA"-1.5V pencells) by watching for the right
polarity on the back of the computer (1). (Batteries
for the computer are not included in this item. Please
buy them at your located market.)
2. Lead the computer (1) to computer holder (2)
and push the plug of the sensor cables (3) into the
associated socket of the computer (1).
3. Storage the cable connection and put the com-
puter (1) on the computer holder (2) until it clicks
into place.
13