Hendi 580233 Mode D'emploi page 4

Preparation before first use
• Remove all the packing material and protection
film (if applicable).
• Keep the packaging if you intend to store your ap-
pliance in the future.
• Check to make sure the appliance is undamaged.
In case of any damage, contact the supplier im-
mediately and DO NOT use the appliance.
Insert the batteries
• Open the battery compartment cover at the bot-
tom of the appliance.
• Insert 3 x 1,5V batteries (Type: AAA, not included)
according to the polarity markings (+) and (-) on
• After few seconds, the LED display (2) as below:
EN
Note: When the symbol
display (2), the batteries are going to exhaust.
Then, you should replace with a new set of batter-
ies. Please replace all 3 batteries at the same time.
Operation
(A). Weighting mode
• Place the appliance on a level, stable, clean,
heat-resistant and dry surface.
• Before switch on the scale, DO NOT put any ob-
jects on the weighting platform (5).
(B). Measure with a TARE function
• This TARE function allows user to weight different
object consecutively without removing previous
object from the weighting platform (5). E.g. Sub-
tract the weight of the container as below.
1. When the appliance is OFF, press the ON / OFF
button (3) to enter weighting mode. You can
start to weight when "0" is shown on the LED
display (2).
4
TARE TARE
appears on the LED
• Clean the weighting platform (5) with a slighted
damped cloth.
• This is a battery-operated scale. Insert 3 x 1,5V
batteries (Type: AAA, not supplied) in the battery
compartment (4) which is at the bottom of the
scale. (See ==> Insert the batteries)
• Press "ON / OFF" button (3). The scale is now
ready for use.
the batteries and inside the battery compartment
(4).
• Close the compartment cover. The LED display (2)
first as below:
g
g
DO NOT mix up the new and old batteries.
DO NOT dispose of exhausted batteries together
with the other household waste. Please follow the
local ordinances and recycling instruction.
• Press the ON / OFF button (3) to switch ON the
appliance in ready mode.
• Next, place the object that you want to weight on
the weighting platform (5).
TARE TARE
ON/OFF ON/OFF
g