Connect Dishwasher - Haier DW-7777-01 Installation

English
18. Remove cardboard from under dishwasher.
It is okay if dishwasher fits tightly into cabinet opening. Do not remove
19. align front of dishwasher door panel "Y" with cabinet doors
"z". You may need to adjust alignment to for the appropriate
appearance.
20. Check that leveling legs "aa" are firmly
against the floor. Close and latch the door,
and place level against the front panel "bb".
Check that dishwasher is plumb. adjust
leveling legs or add shims under rear wheels
until dishwasher is level. note: Shims must
be securely attached to floor to prevent their movement
when the dishwasher is operated. Repeat for other side of
dishwasher. Place level against top front opening of tub
"CC". Check that dishwasher is level from side to side. If
dishwasher is not level, adjust front legs up or down until
dishwasher is level.

coNNEcT DIshWAshER

Electrical connection
Check electrical requirements (see page 8). You must:
• Have the correct electrical supply and
recommended grounding method.
• Check that power supply is disconnected.
using a power supply cord
19
Tilt dishwasher backward to move into opening.
Once in position, support front of dishwasher by
hElpful TIp:
insulation blanket- it reduces the sound level.
hElpful TIp:
Prop up one side of frame to hold dishwasher up
off floor when adjusting front legs.
If you are:
direct wiring
hElpful TIp:
built-up floors.
lowering or shimming front feet.
use steps:
1-4
1a
Y
Z
BB
AA
CC