Haier DW-7777-01 Installation page 15

11c. WAsTE DIsposER - WITh No AIR GAp
1. Remove the disposer knockout plug.
Do not cut end of drain hose.
2. attach drain hose "I" to disposer inlet "n" with large
spring-type clamp "K".
This connecting "n" MUST be made before drain trap
"O" and at least 20" (50.8 cm) above the floor where dishwasher will be
installed.
3. The drain hose must be looped up and securely fastened
to the underside of the counter before going to the drain.
Hose loop must be a minimum 30 inches (76.8cm)
above floor. (Go to step 12)
11d. No WAsTE DIsposER - WITh No AIR GAp
1. Cut end of drain hose "I" (do not cut ribbed section).
2. Attach drain hose to waste tee "P" with 1-1/2" to 2" (3.8 to 5 cm) screw-type
clamp* "M". The connection "P" MUST be made before drain trap "O" and
at least 20" (50.8 cm) above the floor where dishwasher will be installed.
3. The drain hose must be looped up and securely fastened to the underside
of the counter before going to the drain. hose loop must be a minimum 30
inches (76.8cm) above floor. (Go to Step 12)
To reduce the vibration of the hose, keep the hose away from the
floor and the edge of the hole where it passes through the cabinet.
* Parts available from local plumbing supply stores.
Insert drain hose "I" into hole cut in cabinet and guide
toward the back center of opening where drain connection
will be made.
hElpful TIp:
English
14