R&G Tail Tidy Instructions De Montage page 3

Page | 3

Fit new licence plate light to new licence plate bracket and tighten. (note it will be necessary to cut
the wires to the OEM license plate light in order to join them to the R&G light with the connectors
supplied, see wiring directions above).

Fit the smaller supplied heat shrink supplied over wires.

Fit the larger rubber grommet into the cable hole in the under-tray as shown in picture 10.

Feed all wires through the newly fitted rubber grommet as original use the larger heat shrink to
tidy up all the wires.

Using the three original bolts (put bolts though from underneath as original) secure the new
licence plate bracket as shown in picture 10.

Reconnect all wiring and wiring plugs as original. Using wiring clips and cable ties from kit
secure wires to new licence plate bracket and the wiring loom to the frame as original.

Fit licence plate to new licence plate bracket.

IMPORTANT: IF FITTING A FULL-SIZE LICENCE PLATE AND PLACING IT FAR
DOWN ON THE LICENCE PLATE HANGER, THERE IS A SMALL CHANCE OF THE
LICENCE PLATE HITTING THE BACK WHEEL UNDER HEAVY LOAD AND OVER
LARGE BUMPS IN THE ROAD. IT IS YOUR RESPONSIBILITY TO CHECK FOR
THIS POSSIBILITY AND TAKE AVOIDING ACTION. FAILURE TO CHECK THIS
COULD RESULT IN SERIOUS INJURY.

Refit pillion seat.

Depending on local laws, attach enclosed red reflective tape in an appropriate location.

Please test the indicators and licence plate illuminator before riding.
4
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Original Licence plate illuminator = Blue--------------Yellow
R&G Licence plate illuminator = Black--------------Red
1
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
2
5
R&G Racing
www.rg-racing.com Email:
3
6
info@rg-racing.com