Kenmore 592-491070 Manuel D'utilisation Et Consignes De Sécurité page 23

Cleaning the exterior
Turn off the water faucets after finishing the day's washing.
This will shut off the water supply to your Washer and prevent
the unlikely possibility of damage from escaping water. Leave
the door open to allow the inside of your Washer to dry out.
Use a soft cloth to wipe up all detergent, bleach or other spills as
they occur.
Clean the following as recommended:
Control Panel – Clean with a soft, damp cloth. Do not use
abrasive powders or cleaning pads. Do not spray cleaners
directly on the panel.
Cabinet – Clean with soap and water.
Cleaning the interior
Clean the interior of your Washer periodically to remove any dirt,
soil, odor, mold, mildew, or bacterial residue that may remain in
your Washer as a result of washing clothes.
Failure to follow these instructions may result in unpleasant
conditions, including odors and/or permanent stains on your
Washer or laundry.
Hard water deposits may be removed, if needed. Use a cleaner
labeled "Washer safe".
Cleaning the dispensers
The automatic dispenser may need to be cleaned periodically
due to laundry additive buildup.
1. Pull out the detergent liquid from detergent compartment.
2. Remove the siphon cap from the fabric softener and bleach
compartments.
Siphon cap
3. Wash all of the parts under running water.
4. Clean the dispenser recess with a soft brush.
5. Reinsert the siphon cap and push it firmly into place.
6. Push the dispenser back into place.
7. Run a Rinse+Spin cycle without any load in your washer.
Kenmore_Washer_Good-02681B-02_EN.indd 23
All manuals and user guides at all-guides.com
Washers can be damaged if water is not removed from hoses
and internal components before storage.
Prepare your Washer for storage as follows:
■ Select the Quick Wash cycle and add bleach to the
■ Turn the water faucets off and disconnect the inlet hoses.
■ Unplug your Washer from the electrical outlet and leave your
■ If your Washer has been stored in below–freezing
We recommend cleaning the debris filter when water does not
drain well.
1. Open the filter cover by pressing and pulling the handle of
2. Unscrew the drain cap by turning it counterclockwise.
3. Hold the cap on the end of the drain tube and slowly pull it
4. Remove the debris filter cap.
Storing your washer
automatic dispenser. Run your Washer through the cycle
without a load.
Washer door open to let air circulate inside the tumbler.
temperatures, allow time for any leftover water in your
Washer to thaw out before use.
Cleaning the debris filter
the filter cover with your finger.
out about 6inches (15cm) and drain off all the water.
Step 1 Step 2
23
2009-07-23 ¿ÀÈÄ 4:18:15