Botboundary® Strips - shark ION RV870 Série Guide D'utilisation

To keep your robot away from certain areas, such as pet bowls, fragile objects, power strips,
or doorways, use the BotBoundary strips to quickly and easily create "no-go zones".
BotBoundary strips
BotBoundary strips
Identify areas or objects you want the robot to avoid.
4-inch
Min.
Generally, BotBoundary strips are not needed
on stairs because your robot's cliff sensors will
prevent it from falling off ledges. For your robot's
cliff sensors to work properly, all runners, rugs, or
carpets must be at least 4 inches from any stairs
(or extend over the edge of the stairs.)
If a runner, rug, or carpet edge is less than
4 inches from the stairs and can't be moved,
use a BotBoundary strip to block off the stairs.
NOTE: To prevent bumping, place strips at least 2 inches in front of the object you want to block off.
s h a r kc l e a n . c o m
USING THE SHARK ION™ ROBOT
BotBoundary® strips
Cut the BotBoundary strip to the desired length
(18˝/45cm minimum) so that it spans the length
of the doorway or object you want to block off.
For best results, make sure your BotBoundary strip
is completely flat against the floor. Make a closed
loop around an object, or place the strips between
fixed objects, like door frames or the legs of a couch,
to create no-go zones.