Www.bresser.de/Download/Camlablite_Junior - Bresser Junior 40x-1024x Mode D'emploi

How do I install the software?
1. You can download the setup file for installa-
tion here:

www.bresser.de/download/CamLabLite_Junior

2. Start the installation with a double click on
the .exe file and follow the instructions of the
installation manager.
3. It is not necessary to install a special driver.
The camera is automatically recognized by
your Windows operating system.
Using the MicrOcular
Preparation
1. Slide a specimen under your microscope and
focus on it.
2. Remove the eyepiece and Barlow lens from
the eyepiece support and the dust cap from
your MikrOkular and then install the MikrOku-
lar into the eyepiece support instead of the
Barlow lens.
3. Start your PC if you haven't yet and connect
your MikrOkular to the USB port of your com-
puter.
4. Start the „CamLabLite_Junior" software and
activate the camera by clicking on „USB Vi-
deo Device.
5. Click on „Snapshot" to take a picture or on
„Capture" to record a video.
6. Click on the floppy disk icon to save the
image or capture.
Troubleshooting
Error Solution
No recognizable • Turn on light
image • Readjust focus
• Check Windows privacy
settings
Image flickers • If necessary, increase
(while observing resolution of graphics
with MicrOcular) card
= Monitor • Adjust brightness at the
refresh rate not dimmer of the microscope
adequate • Disable automatic expo-
sure
Make sure your microscope has a long service
life.
Clean the lens (objective and eyepiece) only
with the cloth supplied or some other soft lint-
free cloth (e.g.microfibre). Do not press hard as
this might scratch the lens.
Ask your parents to help if your microscope is
really very dirty. The cleaning cloth should be
moistened with cleaning fluid and the lens wi-
ped clean using little pressure.
Make sure your microscope is always protec-
ted against dust and dirt. After use leave it in
a warm room to dry off. Then install the dust
caps and keep it in the case provided.
EN
15