Technical Data - ARTHUR MARTIN AWY 61013WI Notice D'utilisation

18
Problem
You cannot open the ap‐
pliance lid.
The appliance makes an
unusual noise.
The washing results are
not satisfactory.
You cannot set an op‐
tion.
After the check, activate the appliance.
The programme continues from the point
of interruption.
If the problem occurs again, contact the
Authorised Service Centre.
If the appliance shows other alarm codes
(the indicator of button
Deactivate and activate the appliance. If
the problem continues, contact the
Authorised Service Centre.

TECHNICAL DATA

Dimension
Electrical connection
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, except
where the low voltage equipment has no protection
against moisture
Water supply pressure
1)
Water supply
Possible solution
• Make sure that the washing programme is finished.
• Set the drain or the spin programme if there is water in the
drum.
• Make sure the levelling of the appliance is correct. Refer to
'Installation'.
• Make sure that the packaging and/or the transit bolts are re‐
moved. Refer to 'Installation'.
• Add more laundry in the drum. The load may be too small.
• Increase the detergent quantity or use a different detergent.
• Use special products to remove the stubborn stains before
you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
• Make sure that you press only the wanted button(s).
flashes in red).
Width/ Height/ Depth/ To‐
tal depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
Service
We recommend the use of original spare
parts.
When contacting the Authorised Service
Centre, make sure that these data are
available. You can find the information on
the rating plate: model, PNC and Serial
Number. (Mod., Prod. No., Ser. No.)
400 mm/ 890 mm/ 600 mm/ 600 mm
220 - 240 V
2200 W
10 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water