GET RX1 RPO Guide D'installation page 5

ATTENTION:
OEM handlebar commands to change maps and
launch control will not work after installing GET RX1
Pro ECU. To grant proper functionality and reliability
use only GET Map Switch (included in the kit) and
GET LC-GPA module (sold separately).
5.
If included in the kit, install
GET WiFi-COM by following the
procedures in the dedicated manual.
C. IDLE REGULATION
Idle issues may be caused by wrong TPS calibration: follow these
steps to get the best performances from your GET RX1 Pro ECU.
BEFORE STARTING THE CALIBRATION PROCEDURE,
MAKE SURE THE ENGINE STOP SWITCH IS IN RUN
POSITION AND THE THROTTLE IS COMPLETELY CLOSED.
1.
Find the throttle body: check
on your motorbike's workshop
manual where to find it. Rotate
the red
adjuster counterclockwise for
7 rounds.
2.
Perform the RESET TPS procedure as described in the
"ZERO TPS CALIBRATION" section of GET RX1 Pro manual.
throttle position
5
7
ROUND
EN