GET RX1 RPO Guide D'installation page 4

REMEMBER TO WORK UNDER SAFETY CONDITIONS
AND TO KEEP THE ENGINE TURNED OFF.
1.
This ECU has been developed for bikes without power
restrictors, such as DB Killer, catalyst, lambda sensor, air
restrictors: check on your motorbike's workshop manual
where to find them. Remove the power restrictors before
installing GET RX1 Pro ECU.
2.
Find the OEM ECU: check on
your motorbike's workshop manual
where to find it. Press the retainer
clip of the OEM ECU connector before
pulling it: make sure to remove the
connector without damaging it.
3.
Connect GET RX1 PRO ECU to
OEM connector. Make sure the
connector is properly plugged in, and
the retainer clip is fully engaged.
4.
Install GET Map Switch by
following the instructions in "Map
Switch Installation" Section in
GET RX1 Pro manual.
EN
4