Care And Cleaning - BASETech D90D25ESLRIII-N1 Notice D'emploi

Problem
The error code "ERROR - - 1"
appears on the display and beeps
are sounding: The product is
overheated.
The error code "ERROR - - 2"
appears on the display and beeps
are sounding: The product is
undercooled.
The error code "ERROR - - 3"
appears on the display and beeps
are sounding: The microwave
sensor is defective.

15. Care and cleaning

Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these could damage the
housing or even impair the functioning of the product. Do not use harsh or scratching brushes, sponges,
sharp metal scrapers etc., as they scratch the surfaces and may damage the view window.
Do not use steam cleaners to clean the product. The steam is under pressure and it may condense on
electrical components inside the device and cause short circuits.
Never submerge the product or the mains cable in water or other liquids!
Cleaning is an important aspect of handling the product safely and prevents many heath hazards.
• Turn off the product and disconnect it from the power outlet before cleaning. Let the product cool down to room
temperature.
• Open the door.
• Clean the product and remove food residue regularly. Failure to clean the product regularly can impair the surfaces
and greatly reduce its service life. It may also impair the safety and functioning of the device.
• Wipe away any condensation or drops of water with a soft cloth. Condensation can occur when moist air comes
into contact with a cold surface. At very high temperatures, oil and grease may evaporate and form as a greasy film
on surfaces after cooling down.
• Clean the housing exterior with a damp, soft cloth. The mains cable should be cleaned with a dry cloth. Make sure
that no water enters the openings of devices into the product.
• Use a damp cloth to clean the door, the view window, the door seal, the cooking chamber and all adjacent
components.
Possible cause and solution
Let the microwave cool down to room temperature. As soon as the
microwave oven has reached room temperature, the beeps cease
sounding. Press the button Stopp/Sperre (stop/lock).
Let the microwave oven warm up to room temperature. As soon as
the microwave oven has reached room temperature, the beeps cease
sounding. Press the button Stopp/Sperre (stop/lock).
Press the button Stopp/Sperre (stop/lock). The beeps cease sounding.
Consult a specialist workshop.
51