Mounting The Surveillance Camera; Choosing The Location (Fig. 12); Wall- Or Ceiling-Mounting (Fig. 14) - SOMFY Visidom OC100 Manuel D'installation

OC100
c W
onfiguring the i
To complete the installation of your camera for use with the Wi-Fi:
a. Click the
b. Select the "Advanced" button to open the advanced configuration menu and enter the default
administrator password 123456.
c. In the "Wi-Fi parameters" section, select your Wi-Fi network and enter the passphrase for your
hub. (Fig. 9)
The camera
(for example: !@#$%,). If necessary, the passphrase for your hub will have to be changed.
d. Save the parameters.
e. If you have connected the camera with an Ethernet cable, disconnect the cable.
f. The camera will disconnect for approximately 40 seconds before resetting. The green LINK
light stays on when the camera is connected to the Wi-Fi network. (Fig. 10)
g. Update the camera status to be able to view its image.
If the Wi-Fi connection fails, you must reconfigure the camera by pressing the RESET button on the
power cable for 5 seconds (Fig. 11). The red indicator light flashes then comes on steady. After 40
seconds, the green connection indicator light gives 3 short flashes then 1 long one. You can then
repeat the parameter setting, see page 6.

mOuntinG tHe SurveillAnCe CAmerA

c
hoosing the location
The camera can be fixed to a wall or under eaves.
You must not direct your surveillance camera towards public thoroughfares or neighbours:
the surveillance camera must not be used to film public thoroughfares or other locations
which are the property of others. It is your responsibility to check the camera's orientation
to ensure these situations do not occur.
The power plug and socket must be installed inside the house or in a sealed unit. (Fig. 13)
If using the camera with a wire connection, you can connect it to your box/ADSL
router using an RJ45 Ethernet extension. Use a female/female Ethernet adapter to
connect the extension to the camera's Ethernet adapter.
W -
all or ceiling
a. Use the mounting holes on the base of the camera to mark the location of the plugs on the
wall or under the eaves.
b. Drill holes and insert the plugs. Position the base of the camera and tighten the screws.
c. Screw the camera onto its base and tighten the locknut (rounded triangular plate).
d. Undo the tilt head ring, then adjust the viewing angle.
e. Position the camera to obtain the desired field of vision.
f. Tighten the locking screw when the camera is in the correct position.
8
-f
i ParaMeters
icon, then .
cannot accept
(f . 12)
ig
- (f
Mounting
passphrases which
. 14)
ig
include special characters
Copyright © 2015 Somfy SAS. All rights reserved.