Quick Parameter Setting Via The Direct Wi-Fi Connection; Parameter Setting Via Ethernet Cable - SOMFY Visidom OC100 Manuel D'installation

Q
uick ParaMeter setting via the direct
a. The green connection indicator light performs a cycle of flashes (1 slow
flash followed by 3 rapid flashes) to indicate that the camera is transmitting
a Wi-Fi signal. (Fig. 5A)
b. Open up the smartphone or tablet's Wi-Fi parameters. Log into the Wi-Fi
network which has the identifier "HD-000xxx", which corresponds to the DID
number given on the back of the camera (CGXX-000xxx).
c. Enter the following network passphrase: 12345678.
d. Save these parameters. The smartphone (or tablet) is now directly
connected to the camera. You can now re-enter the parameters for your
Wi-Fi network. (Fig. 6A)
e. Open the "Somfy VISIDOM" application on your smartphone or tablet.
f. Click on "Add a camera" then "Search". The camera's DID should be
displayed.
g. Select the camera, then enter a name (of your choice) and the default
password 123456. Save these parameters. (Fig. 7A)
► Wait for the connection to be set up: the green connection indicator light
on the camera gives 2 long then 2 short flashes. (Fig. 8A)
h. Once the camera is connected, click
password. (Fig. 9)
i. Then, follow the instructions in the section "Configuring the Wi-Fi
parameters", page 8.
P
araMeter setting via
a. Connect the camera to your box/ADSL router using the USB/Ethernet micro USB
adapter (supplied). (Fig. 5B)
► The camera's internet connection will be active after approximately 40 seconds,
when the green connection indicator light comes on steady. (Fig. 6B)
b. Open the "Somfy VISIDOM" application.
c. Click on "Add a camera" then "Search". The DID identifier (given on the back of the
camera) is displayed. Select the corresponding camera, then enter a name (of your
choice) and the default password 123456. Save these parameters. (Fig. 7B)
d. The camera is now connected to the internet and linked to the application installed
on your smartphone or tablet. (Fig. 8B)
e. Click and save a new personal password. (Fig. 9)
f. If you wish to configure the camera using the Wi-Fi, follow the instructions in the
section "Configuring the Wi-Fi parameters", page 8.
Copyright © 2015 Somfy SAS. All rights reserved.
W
e
thernet cable
-f
i i connection
and save a new personal
OC100
7