Télécharger Imprimer la page

Quick Parameter Setting Via The Direct Wi-Fi Connection; Parameter Setting Via Ethernet Cable - SOMFY VISIDOM IC100 Manuel D'installation

Masquer les pouces Voir aussi pour VISIDOM IC100:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
Q
uiCk parameter setting via the direCt
a. The green LINK light performs a cycle of flashes (1 slow flash followed by 3 quick
flashes) to indicate that the camera is transmitting a Wi-Fi signal. (Fig. 4A)
b. Open up the smartphone or tablet's Wi-Fi parameters. Log into the Wi-Fi network
which has the identifier "HD-000xxx", which corresponds to the DID number given
on the back of the camera (CGXX-000xxx).
c. Enter the following network passphrase: 12345678.
d. Save these parameters. The smartphone (or tablet) is now directly connected to
the camera. You can now re-enter the parameters for your Wi-Fi network. (Fig. 5A)
e. Open the "Somfy VISIDOM" application on your smartphone or tablet.
f. Click on "Add a camera" then "Search". The camera's DID should be displayed.
g. Select the camera, then enter a name (of your choice) and the default password
123456. Save these parameters. (Fig. 6A)
► Wait for the connection to be set up: the LINK light on the camera gives two long
then two short flashes. (Fig. 7A)
h. Once the camera is connected, click
(Fig. 8)
i.
Then, follow the instructions in the section "Configuring the Wi-Fi parameters", page
8.
p
arameter setting via
a. Connect the Ethernet cable to your ADSL hub/router and to the back of the camera.
(Fig. 4B)
► The camera's internet connection will be active after approximately 40 seconds,
when the green LINK light comes on steady. (Fig. 5B)
b. Open the "Somfy VISIDOM" application.
c. Click on "Add a camera" then "Search". The DID identifier (given on the back of the
camera) is displayed. Select the corresponding camera, then enter a name (of your
choice) and the default password 123456. Save these parameters. (Fig. 6B)
d. The camera is now connected to the internet and linked to the application installed
on your smartphone or tablet. (Fig. 7B)
e. Click
and save a new personal password. (Fig. 8)
f. If you wish to configure the camera using the Wi-Fi, follow the instructions in the
section "Configuring the Wi-Fi parameters", page 8.
Copyright © 2015 Somfy SAS. All rights reserved.
w
e
thernet Cable
-F
i
i ConneCtion
and save a new personal password.
IC100
7

Publicité

loading