Publicité
Les langues disponibles
Les langues disponibles
V1.0
Contents:
• Long Barrel Air Hammer
• (5) Chisels
IDENTIFICATION KEY
A
Retainer Spring
B
Cylinder
C
Trigger
D
Air Inlet
E
Air Regulator
F
Chisel, Tapered Punch
G
Chisel, Weld Buster/Bolt
Cutter
H
Chisel, Bushing Cutter
I
Chisel, Ripper
J
Chisel, Flat Punch
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
INSTALL AIR BODY PLUG
Prepare a standard 1/4 in. NPT male air body plug (sold separately) for use
with your tool.
1.
Wrap the external threads of the air body plug with sealant tape.
a.
Wrap tape in a clockwise direction so it will not unravel.
b.
Do not tape all the threads. Leave several leading threads
unwrapped for easier alignment.
2.
Screw the air body plug into the tool's air inlet (D) and tighten with a
wrench until snug.
3.
Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is connected
directly to the air tool. To overcome this, connect a leader hose to the tool.
A quick coupler may then be used to connect the leader hose to the air line
hose.
Visit www.princessauto.com for more information
7 pc Extra Long-Barrel Air Hammer Kit
• Spring Retainer
9004052
Fig. 1
9
Publicité
