Publicité
Les langues disponibles
Les langues disponibles
9004052
6.
Never use oxygen, combustible gas or any other bottled gas as a
power source. Any power source other than an air compressor could
cause an explosion and serious personal injury.
7.
Turn OFF the valve and discharge any remaining air pressure after each
use or before adjusting the tool.
8.
Do not leave the air tool unattended with its compressed air supply on.
Turn off the compressed air supply and bleed the air tool of any
remaining compressed air before leaving the air tool unattended.
9.
Serious injury may occur from loose debris being propelled at high speeds
from the compressed air stream. Always wear OSHA approved safety glasses
to protect the eyes during operation of the air compressor.
10. Always turn off the air compressor and drain tank pressure completely
before attempting maintenance or attaching air tools. Release pressure
slowly from the system.
11.
Serious injury or death may occur from inhaling compressed air. The air
stream may contain carbon monoxide, toxic vapors or solid particles.
Never inhale compressed air directly from the pump or air tool.
POWER TOOL PRECAUTIONS
1.
Do not use any power tool with a malfunctioning power switch or control.
A power tool that fails to respond to the controls is dangerous and can
cause an injury. A qualified technician must repair and verify the power
tool is operating correctly, before it can be used.
2.
Avoid unintentional starts. Ensure the switch is off when connecting to
the power source.
3.
Disconnect the power source before installing or servicing the tool.
4.
Never force the tool. Excessive pressure could break the tool, resulting
in damage to your workpiece or serious personal injury. Excessive
pressure is the cause if your tool runs smoothly under no load, but
roughly under load.
5.
Only use an accessory that exceeds the Beats Per Minute rating (see
Specifications). Ensure the accessory is tightly installed.
6.
Before using the tool on a workpiece, test the tool by running it at the
highest no load speed for at least 30 seconds in a safe position. Stop
immediately if there is any abnormal vibration or wobbling. Check the
tool to determine the cause.
7.
Never touch the tool accessory or workpiece during or immediately
after use. They may be hot and could inflict a burn injury.
6
7 pc Extra Long-Barrel Air Hammer Kit
For technical questions call 1-800-665-8685
V1.0
Publicité
