Setting And Starting A Washing Programme - Electrolux GA553IF Notice D'utilisation

14 electrolux
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C.
– The indicator lights for function buttons
A, B, and C start to flash.
4. Press function button B.
– The indicator lights for function buttons
A and C go off.
– The indicator light for function button B
continues to flash.
5. Press function button B again.
– The end-of-programme indicator light
comes on. The rinse aid dispenser is
active.
6. Switch off the appliance to save the op-
eration.

Setting and starting a washing programme

Set the washing programme with the
door ajar. The washing programme only
starts after you close the door. Until then
it is possible to modify the settings.
Do these steps to set and start a washing
programme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Select a washing programme. Refer to
the chapter 'Washing programmes'.
– The indicator light of the programme
comes on.
– The phase indicator lights for the pro-
gramme start to flash.
– The programme button indicator light
flashes.
4. Close the door. The washing programme
starts automatically.
– The phase indicator lights go off but not
the indicator light of the phase in oper-
ation.
– The programme button indicator light
is on with a static light.
When the washing programme oper-
ates, you cannot change the pro-
gramme. Cancel the washing pro-
gramme.
Warning! Only interrupt or cancel a
washing programme if necessary.
Caution! Open the door carefully. Hot
steam can come free.
To deactivate the rinse aid dispenser do the
above steps until the end-of-programme in-
dicator light goes off.
To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid
dispenser.
3. Adjust the water hardness setting to
the highest level.
4. Do a washing programme without
dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the rinse aid dosage.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point
of interruption.
Cancelling a washing programme
1. Press and hold function buttons B and C.
– The set washing programme light goes
off.
– The phase indicator lights go off.
– The programme button indicator light
comes on.
– The end-of-programme indicator light
comes on.
2. Release function buttons B and C to can-
cel the washing programme.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme .
Fill the detergent dispenser with detergent
before you set a new washing programme.
End of the washing programme
Switch off the appliance in these conditions:
• The appliance stops automatically.
• The end-of-programme indicator light
comes on.
• The indicator light of the completed pro-
gramme stays on.
1. Press the on/off button.
2. Open the door.
3. For better drying results, keep the door
ajar for some minutes before you remove
the dishes.