Cardin Elettronica RCQ-3G/WF Mise En Service Et Utilisation page 22

All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
- the received command will be carried out straight away.
• Procedures that are carried out via USB using the programming base ignore the "PPT" parameter
setting and will be carried out even if the 'rapid memorization function' has been disabled on the
receiver.
To set up the new transmitter for rapid memorization, proceed as follows:
- Remove the upper cover from the transmitter to be memorised and from the transmitter that has already been
memorised as shown in the drawing below (det. a).
- Place the transmitter A, that has already been memorised in the receiver, near the new transmitter B (det. b).
- Using a pointed object press and release the MR button on both transmitters (in sequence or simultaneously).
- The orange LEDS on the transmitters will flash slowly.
- Press and release a channel button on transmitter A that is already present in the receiver (det. c).
- The led of the new unit B will remain lit for 3 seconds to confirm memorization (det. d).
Transmitter B will now command the receiver exactly like transmitter A.
2G/3G and WF cards
Dedicated cards that permit the receiver to hook up to a 2G/3G mobile network ( local network for the
WF card) and allows it to access a series of remote control functions. To connect to a 2G/3G mobile
network a telephone SIM card for data traffic is required. The details for the installation and management
of the 2G/3G and WF connections are explained in detail in the software instruction manual which can
be downloaded from the Software Download Centre on the website www.cardin.it.
2G/3G modem functions
The modem on board the receiver "3G CARD fig. 1" uses the mobile phone network to manage the
user codes stored in the receiver working together with the CardinTX_SW software and can also
Drawing number : DM0910
directly activate the individual channels (relays) by calling them directly or via SMS/APP.
TRQ504
Product Code :
Draft : P.J.Heath Attention: In receivers fitted with SIM VODAFONE-CARDIN the direct call and SMS functions are excluded. Date : 29-10-2013
CARDIN ELETTRONICA S.p.A - 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/401831
WiFi card functions
The receiver fitted with a WF card works in a similar way to the version with a 2G/3G card and a SIM VODAFONE-
CARDIN SIM card, using the local WiFi network in place of the mobile phone network.
This configuration, which only uses the internet fore its communications connection, has unlimited connection
time with the Gateway Cardin.
To connect the receiver to the WiFi network you must have the right credentials which should be memorised in
the receiver using the software CardinTX_SW.
The WiFi card supports the following network security protocols:
• Open
• WEP-64 and WEP-128 (open mode only, NOT shared mode)
• WPA2-PSK (AES only)
• WPA1-PSK (TKIP only)
• WPA-PSK mixed mode (some access points, not all are supported)
Caution: Before installing make sure that the Wifi card is compatible with the function modes available on
the network to which you intend to connect up with.
The management of the modem functions can be found in the receiver menu "6) MODEM".
Some of the options are always present and others will be enabled according to the status of the modem.
The fields in menu "6) MODEM" will change according to the type of card inserted in the receiver. The
default setting assumes that a 2G/3G card has been inserted.
MR
1
A
Description : MEMORIZZAZIONE CODICE TX-TX
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
MR
B
Drawing number :
DM0911
Product Code : TXQ504C4
Draft : P.J.Heath Date : 29-10-2013
CARDIN ELETTRONICA S.p.A - 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/401831
22
All rights reserved. Unauthorised copying or use of the information contained in this docum
A
Description : MEMORIZZAZIONE CODICE TX-TX
Drawing number : DM0912
Product Code : TXQ504C4
Draft : P.J.Heath Date : 29-10-2013
CARDIN ELETTRONICA S.p.A - 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax
B
Description : MEMORIZZAZIONE CODICE TX-TX