Dimplex Gala Manuel D'installation page 23

L
9. Put a small quantity of detergent in the collection reservoir and use the supplied brush to
clean all surfaces including the metal discs and the rubber connection. Don't remove the
rubber connections. (See Figs. 14 and 15).
10. After the reservoir has been cleaned, rise it with clean water.
11. Clean the surface of the damp spreader with the brush and rinse thoroughly with water.
(See Fig.16 and 17).
12. Re-install the unit by following the previous steps in reverse order.
2.7.3 Air filter.
1. Pull the drawer out. (See Fig. 3).
2. Put switch "A" in the "OFF" (0) position. (See Fig. 2).
3. Remove the water tank and place it in a sink with the cap pointing upwards.
4. Carefully pull up the plastic holder of the air filter. (See Fig. 18).
5. Remove the filter combination from the plastic holder.
6. Rinse the filter with clean water and dry it with paper towels.
7. Place the filter back in its holder and ensure that the black part is on the plastic holder.
(See fig. 19).
8. Put the water tank back.
9. Put switch "A" in the "ON" ( I ) position (See Fig. 2).
10. Carefully close the drawer.
2.7.4 Recycling.
All electrical equipment that is sold within the European Union should not be
disposed of as domestic waste at the end of their lifetime, but should be brought to
an appropriate recycle point. Please ask your local authority or dealer for a recycle
point in your neighbourhood.
22 < < < <