System Commissioning; Setting Of The Surveillance Camera Channel (Optional) - Conrad 75 42 70 Notice D'emploi

f) System Commissioning
Push the included MicroSD memory card into the intended slot on the right side of the indoor unit.
Push and hold the activation button at the upper edge of the indoor unit for about one second to switch
on the system.
Push and hold the activation button for two seconds to switch off the system.
After activating the system and checking the image delivered by the surveillance camera on the indoor
unit, optimise the alignment of the surveillance camera, if required.
g) Setting of the Surveillance Camera Channel (Optional)
All wireless surveillance cameras for this system are pre-set to channel 1 ex works.
If you want to connect other surveillance cameras in addition to the included one to the
indoor unit of this set ("Pairing"), ensure that each of these devices uses another channel
than the surveillance camera(s) already installed.
The indoor unit can be used to operate up to four wireless surveillance cameras. Proceed as described
in the chapter "CAMERA SETUP" (Surveillance Camera Setup) to set the monitor channel for a surveil-
lance camera.
57