Conrad 75 42 70 Notice D'emploi page 55

Drill a hole in the with a diameter of 15 mm where you want to attach the surveillance camera to the out-
door wall through which you can guide the power supply inside.
The power supply cable of the surveillance camera MUST be placed inside because the
plug-in mains adapter must only be used in dry indoor rooms. The plug is protected from
moisture!
It is recommended that you protect all cables in the outdoor area against manipulation by
unauthorised persons by a cable duct.
Screw the surveillance camera to the bottom of the holder with the thread.
Fasten the holder for the surveil-
lance camera. to the wall with the
included screws so that you can
pull the power supply cable of the
surveillance camera through the
hole in the wall.
Loosen the thumb screw at the
camera holder until you can freely
move the thread to which the sur-
veillance camera is attached.
Put the surveillance camera in the desired
position and then tighten the thumb screw
again to fasten the surveillance camera in this
position.
55