Stopping The Vehicle - Reely TQ-Racer Notice D'emploi

k) Stopping the vehicle
To stop the vehicle, proceed as follows:
• Release the throttle/brake lever (2) on the transmitter so that it is in the centre (neutral) position and let the vehicle
roll to a halt. Release the steering wheel (1) as well.
• Once the vehicle is stationary, turn the vehicle off using the on/off switch (see image in section 9e for position).
Warning!
Make sure not to touch the wheels or the drive, and do not move, under any circumstances, the throttle/
brake lever (2) or the steering wheel (1) on the transmitter! Do not hold the vehicle by the wheels!
• Switch the transmitter off using the on/off switch on the transmitter.
Always work in this order - first switch off the vehicle, then the transmitter.
For short pauses in the use of the vehicle, the drive battery can remain connected to the vehicle. If the
device is not used for an extended period of time (e.g. in the event of storage), remove the drive battery
from the vehicle and unplug the connection between the drive battery and the vehicle. Also remove the
battery/rechargeable battery from the transmitter.
Charge the drive battery after using the vehicle.
If the vehicle will not be used for an extended period of time (e.g. winter storage), make sure that the drive
battery is recharged every 2 - 3 months to avoid a damaging deep discharge. The Li-ion drive battery can
be damaged by a deep discharge and become unusable.
47