Setting Up The Transmitter; Switching Off The Controller/Receiver Unit; Inserting The Drive Battery Into The Vehicle - Reely TQ-Racer Notice D'emploi

d) Setting up the transmitter
• Set the "ST TRIM" control dial (9) for directional stability and control dial "TH TRIM" (11) for the motor function in
the centre position.
• Then move the control dial "ST D/R" (8) for the steering dual rate function and control dial "TH D/R" (10) for the
motor dual rate function to the "MAX" position (right limit stop).
• Switch the transmitter on using the on/off switch (3). The red LED (5) should light up.
If the LED (5) flashes, the batteries in the transmitter are empty and must be replaced.
e) Switching off the controller/receiver unit
Switch the vehicle's controller/receiver unit off first.
The on/off switch is located directly next to the control-
ler/receiver unit. Pay attention to the labelling next to the
switch or the image to the right.
• (A) = "ON": Power on
• (B) = "OFF": Switched off
f) Inserting the drive battery into the vehicle
Warning!
The drive battery must not yet be connected to the vehicle. First switch on the transmitter, see section 9c)
and d).
Important!
This vehicle is only suitable for use with a Li-ion/LiPo drive battery with 2 cells (nominal voltage 7.4 V) or a
NiMH drive battery with 6 cells (nominal voltage 7.2 V). When using a drive battery with more cells, there
is a danger of fire resulting from the controller/receiver unit overheating. In addition, the vehicle's drive will
be overloaded and thus damaged (e.g. differential). This will void the warranty.
When using your own rechargeable battery, you must make sure that it has a connection system suitable
for connection to the speed controller and that the polarity is correct (red cable = plus/+, black cable =
minus/-).
Remove the safety clips (A) and fold the bracket (B) on the
battery holder upwards.
Insert the drive battery so that the rechargeable battery's
connection cable is facing backwards. Otherwise, the
connection cable could impair the function of the steering
mechanism.
Push the battery holder bracket down again and fasten it
with the safety clips removed initially.
42