Prepare The Receiver Collar - Petsafe SPT-275 Manuel D'utilisation

Battery Indicator
Battery is at
Handheld Remote is fully functional.
Battery is at
will operate the Receiver Collar, but should
be recharged as soon as possible.
When the Battery Indicator shows the low battery symbol (
Remote soon. When the battery outline is displayed, the Handheld Remote's battery is unable to power
transmissions to the Receiver Collar. The Handheld Remote must be recharged to regain operation.
Handheld Remote Functions for Dog 1
Handheld Remote
Function
Upper Left Button
Lower Left Button
Upper Right Button
Lower Right Button
+2 Boost Button
See 2-Dog System on page 15 for Handheld Remote functions in Dog 2 mode.
Handheld Remote Belt Clip
To remove:
1. Press and hold the Release Lever on the Belt Clip, pulling away from the Handheld Remote.
2. Slide the Belt Clip out of the insert.
To replace:
1. Slide the Belt Clip into the insert until it clicks, locking into place.
STEP 2

Prepare the Receiver Collar

Charge the Receiver Collar
1. Lift the rubber cover protecting the Receiver Collar
Charging Jack.
2. Connect the charger connector to the Receiver Collar
Charging Jack (2A).
3. Plug the charger into a standard wall outlet.
4. Charge the Receiver Collar until the Green Indicator Light
comes on and is solid. Recharges take only 4-5 hours.
5. When charging is completed replace the rubber cover.
⁄ to Full capacity.
2
3
⁄ capacity. Handheld Remote
1
6
Button Colour
Green
Purple
Grey
Grey
Red
www.petsafe.net
Battery is at
Handheld Remote is still
fully functional.
Battery is almost depleted.
Handheld Remote is unable to
operate the Receiver Collar.
⁄ capacity), recharge your Handheld
1
6
Digital Display Response
Tone Only
Spray
Spray Level Up
Spray Level Down
+2 above selected Spray Level
2A
⁄ capacity.
1
3
9