Fit The Receiver Collar - Petsafe SPT-275 Manuel D'utilisation

Receiver Collar LED – Function and Response
Receiver Collar
Function
Receiver Collar is turned on
Unit is on
Spray activation
Low battery condition
Tone being received
STEP 3

Fit the Receiver Collar

Important: The proper fit and placement of your Receiver Collar is
important for effective operation.
To assure a proper fit, please follow these steps:
1. Make sure that the Receiver Collar is turned off.
2. Start with your dog standing comfortably (
3. Place the Receiver Collar on your dog's neck close
to the ears. Centre the unit underneath your dog's
neck, touching the skin (
logo on the front of the unit is upright. Note: It is
sometimes necessary to trim the hair along the path
of the spray. It is important that the spray reaches
your dog's snout to be effective.
Do not shave the pet's neck as this
may increase the risk of skin irritation.
4. Check the tightness of the Receiver Collar by
inserting one finger between the collar and
your dog's neck (
3C
but not constricting.
5. Allow your dog to wear the Receiver Collar for
several minutes then recheck the fit. Check the fit again as your dog becomes more comfortable
with the Receiver Collar.
LED Response
Green LED flashes one time
Green LED flashes once every five
seconds
Red LED flashes between sprays when
Spray Button is held down
Red LED flashes three times every five
seconds
Green LED flashes
3B ). Make sure the PetSafe
). The fit should be snug
www.petsafe.net
).
3A
3B
®
3C
Receiver Collar
Beeper Response
Beeps low to high
None
None
None
Tone beep
3A
11