Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Then spread the arms completely apart and put the rubber pads on them. Position the skids below the grip
points provided by the car manufacturers.
Once the support arm has been correctly positioned, check that it is correctly in place and locked by
simply moving it from right to left.
Lift the vehicle a short distance (all 4 wheels should be about 10 to 15 cm off the ground) and check that the
skids are correctly positioned and that the vehicle is stable. Once this check has been carried out, lift the
vehicle to the desired height and store the remote control.
Maximum loading principle of the lift :
This self-stable lift has been dimensioned to accept a maximum working load (M.W.L.) of 2000kg /4400lbs
as shown in the figures below and regardless of the position of the arms (open angle or fully closed). This
means that it is necessary to respect a loading of 60% of the mass on the front of the lift and 40% on the back
of the lift and vice versa. It is designed to accept a reversible load.
By respecting the alignment of the lift with the longitudinal axis of the vehicle and by positioning the rubber
pads below the gripping points identified by the car manufacturers, you will respect this principle and be able
to lift the load safely. This information is to be found on the lift so that the user does not exceed the maximum
load depending on the situation (position of the engine in the vehicle according to the direction of the lift).
1320lbs
600kg
Front
1200kg
2640lbs
60%
800kg
40%
1760lbs
600kg
1320lbs
880lbs
400kg
400kg
400kg
880lbs
880lbs
1320lbs
880lbs
600kg
400kg
Back
800kg
1760lbs
40%
1200kg
60%
2640lbs
600kg
1320lbs
ERGO LIFT 650
32
Publicité
Table des Matières
