GYS Ergo Lift 650 Manuel D'utilisation Et De Maintenance page 31

1
Step 5: Using the remote control:
Drawbar
support
Press the up button or "↑" to raise the lift. As long as the button is held down, the lift will rise until a double
beep sounds (end position reached by the sensor). Automatically when the button is released, the lift stops.
Press the down button or "↓" to lower the lift. A beep for 2 seconds preceded by the descent of the table will
be heard each time the button is pressed and an audible signal will be emitted throughout the descent to
warn people around the manoeuvre. Automatically when the button is released, the lift stops.
In case of an emergency, it is possible to stop the ascent and descent of the lift by pressing the red emergency
stop button. To disengage it, pull the button and at the same time make a quarter turn.
Step 6: Moving the lift
h- The lift must be raised about 15 centimetres from the ground.
i- Insert the 2 wheels and the safety pins.
j- Lower the lift to the floor.
k- Fold the 4 arms towards the inside of the lift.
l- Move the group close to the lift and place it on the lift as shown in the figure below.
m- Insert the operating tiller at the level of the slot on the lift.
n- Press and push lightly on the tiller to move the lift wherever you want on level ground with no slope
(<3°).
Manoeuvring
STOP
Going up
Down
2
Max position
Min position
ERGO LIFT 650
Limit switch sensor
3
30