Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Rear Panel
12
7
1.
Power Input: Use the included power adapter to power the unit or charge the internal
lithium-ion battery.
2.
Power Button: Press this button to power PRIME GO on. Power on PRIME GO only
after you have connected all of your input devices and before you power on your
amplifiers and loudspeakers.
To power off PRIME GO, press this button and follow the prompts on the touchscreen.
Power off your amplifiers and loudspeakers before powering off PRIME GO.
3.
Rear USB Port: Connect a standard USB drive to this USB port. When you select a USB
drive as a source, you can use the touchscreen to select and load tracks from your USB
drive.
4.
USB B: Use a standard USB cable (included) to connect this USB port to an available
USB port on your computer.
Important: You must use the Engine Prime software to configure the music library on
your SD card or USB flash drive before connecting them to PRIME GO.
5.
Link Port: Use a standard Ethernet cable to connect this port to a computer. PRIME GO
will send time, BPM, and other track data to the compatible Stagelinq lighting and video
software over this connection.
6.
Booth Outputs (1/4" / 6.35 mm): Use standard 1/4" (6.35 mm) cables to connect these
outputs to booth monitors or a booth amplifier system. Use the Booth knob on the top
panel to control the volume level.
7.
Master Outputs (XLR, balanced): Use standard XLR cables to connect these outputs to
loudspeakers or an amplifier system. Use the Master knob on the top panel to control
the volume level.
8.
Master Outputs (RCA, unbalanced): Use standard RCA cables to connect these outputs
to loudspeakers or an amplifier system. Use the Master knob on the top panel to control
the volume level.
9.
Stereo/Mono: Use this switch to set the channel configuration of the Master Outputs:
Stereo (binaural audio using separate left and right channels) or Mono (summed
monaural audio through both left and right channels).
10. Aux Inputs (RCA, unbalanced): Use standard RCA cables to connect these line-level
inputs to an external audio source. Use the Aux Level knob on the top panel to control
the volume level.
11. Mic Inputs (XLR or 1/4" / 6.35 mm): Use standard XLR or 1/4" (6.35 mm) cables (not
included) to connect standard dynamic microphones to these inputs. Use the Mic 1 and
Mic 2 Level knobs on the top panel to control the volume level.
®
12. Kensington
8
9
6
Lock Slot: Use this slot to secure PRIME GO to a table or other surface.
11
10
3
1
4
5
2
9
Publicité
Table des Matières
