Personalisations; Setting The Temperature; Setting The Spin Cycle; Functions - Hotpoint Ariston AVTL 83 Mode D'emploi

Personalisations

Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 6).
The temperature can be lowered, or even set to a cold wash ( ).
Setting the spin speed
Turn the SPIN SPEED knob to set the spin speed for the programme selected.
The maximum spin speeds for each programme are as follows:
Programmes Maximum spin speed
Cottone 800 rpm
Synthetics 800 rpm
Wool 600 rpm
Silk no
The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting symbol
The washing machine will automatically prevent you from selecting a spin speed higher than the maximum speed for
each programme.

To avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by
continuously rotating the drum at a speed which is slightly faster than the normal washing speed. When, despite
repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than the set frequency.
If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.
The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.

Functions

To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set.
Function Ef fect
Super Al l ows f or an
Wash i mpeccabl e
wash, vi si bl y
whi t er t han a
st andar d
Cl ass A wash.
Easy i r on Thi s opt i on
reduces t he
amount of
creasi ng on
f abri cs,
maki ng t hem
easi er t o i ron.
Rapi d Cut s t he
durat i on of
t he wash
cycl e by 30%.
Ext ra I ncr eases t he
Ri nse ef f i ci ency of
t he ri nse.
Comments
Thi s f unct i on i s i ncompat i bl e wi t h t he RAPI D f unct i on.
When t hi s f unct i on i s set , programmes 6, 7, 8, 11 and
Del i cat e r i nse wi l l end wi t h t he l aundr y l ef t t o soak
(Ant i -crease) and t he Ri nse cycl e phase LED
f l ash.
- t o concl ude t he cycl e, pr ess t he START/RESET
but t on;
- t o run t he drai ni ng cycl e al one, set t he knob t o t he
r el at i ve symbol and pr ess t he START/RESET
but t on.
Thi s f unct i on i s i ncompat i bl e wi t h t he SUPER WASH
f unct i on.
Recommended when t he appl i ance has a f ul l l oad or
wi t h l arge quant i t i es of det er gent .
.
Enabled with
pr ogr ammes:
1, 2, 3, 4,
5, 6, 7, 8
All
pr ogr ammes
wi l l except f or
1, 2, 9, 10
and
Dr aining.
1, 2, 3, 4,
5, 6, 7, 8
Rinses
1, 2, 3, 4, 5,
6, 7, 8, and
Rinse
cycles.
7
GB