Disposal; Regulations And Guidelines; Warranty Claims - Exclusion Of Liability; Technical Data - Helios KWL-BE Touch Notice De Montage Et D'utilisation

Installation and Operating Instructions
EN
CHAPTER 3
PRODUCT
INFORMATION
Touch Display Controller – KWL-BE Touch
When storing for a prolonged time the following measures should be taken to avoid
damaging influences:
• Protection by dry, air-tight and dustproof packaging (plastic bags with drying agent
and moisture indicators).
• The storage place must be waterproof, vibration-free and free of excessive tempe-
rature variations.
Damage caused by improper transportation, storage or commissioning must be verified
and is not covered by warranty.
2.4

Disposal

Parts and components of the unit, whose service life has expired, e.g. due to wear and
tear, corrosion, mechanical load, fatigue and/or other effects that cannot be directly
discerned, must be disposed of expertly and properly after disassembly in accordance
with the national and international laws and regulations. The same also applies to auxi-
liary materials in use, such as oils and greases or other substances.
The intended and unintended further use of worn parts, e.g. impellers, rolling bearings,
filters, etc. can result in danger to persons, the environment as well as machines and
systems. The corresponding operator guidelines applicable onsite must be observed
and applied.
2.5

Regulations and guidelines

If the unit is installed correctly and used to its intended purpose, it conforms to all appli-
cable regulations and CE guidelines.
2.6 Warranty claims – Exclusion of liability
All versions of the documentation relating to the unit must be observed, otherwise the
warranty shall cease to apply. The same applies to liability claims against the manufac-
turer.
The use of accessory parts which are not recommended or offered by Helios is not
permitted. Any potential damages are not covered by the warranty.
Changes and modifications to the unit are not permitted and lead to a loss of conformity.
Any warranty and liability shall be excluded in this case.
3.1

Technical data

KWL-BE Touch
Voltage
Power consumption
Protection category
Dimensions mm
Frame colour
3.2

Dimensions

for flush-mounted installation
12-48 V DC
1.0 W
IP20
W 87 x H 80 x D 33
KWL-BE Touch white
KWL-BE Touch black
3
20245-001
20244-001
Fig.1