Activating The Remote Flash Mode As Slave; Deactivating The Remote Mode - Metz MECABLITZ 58 AF-1 digital Mode D'emploi

19.3 Activating the remote flash mode as Slave

BEEP
Select
• Press the
Remote
appears on the display.
FB
Set
• Use the
from the menu. The selected menu option is indica-
ted by a dark bar.
• Press the
"Remote".
• Use the
Remote
Slave
Slave". The setting is effective immediately.
• Press
Set
If the
switch back to normal automatically after approxi-
mately 5 seconds.
☞ The Slave flash unit must be set to the same
remote channel as the Master or Controller flash
SLAVE
unit. The Slave flash mode (P-TTL remote) cannot
GROUP:A AZoom 35
be set manually on the Slave flash unit, because
CHANNEL:1
the Master and Controller flash units are control-
Para Sel
led automatically!
• Store the setting with the
is not pressed, the settings will be saved automatical-
ly after approximately 5 seconds.
Sel button repeatedly until "Select"
and buttons to select "Remote"
Set button to confirm the selection of
and buttons to select "Remote
repeatedly to return the display to normal.
button is not pressed, the display will
button. If the button
Setting the parameters
• Press the Para button repeatedly until the desired parameter appears on the
display. Here it is possible to make settings for...
- EV: Flash exposure correction; -3 EV to +3 EV in increments of one third are
possible
- Channel: Remote channel; channels 1 to 4 are possible
- and MZoom: Reflector position; 24mm (12mm with wide angle attachment)
up to 105mm are possible.
+
–
• Use the and buttons to make the desired settings.
• Store the setting with the button. If the button
tings will be saved automatically after approximately 5 seconds.

19.4 Deactivating the remote mode

• Press the Sel button repeatedly until "Select"
appears on the display.
• Use the and buttons to select "Remote"
from the menu. The selected menu option is indicated
by a dark bar.
• Press the Set button to confirm the selection of
"Remote".
• Use the and buttons to select "Remote
OFF". The setting is effective immediately.
• Press repeatedly to return the display to normal.
If the button is not pressed, the display will
switch back to normal automatically after approxi-
mately 5 seconds.
is not pressed, the set-
BEEP
Select
Remote
FB
Set
Remote
OFF
Set
139