Safety Instructions; Specified Conditions Of Use - ALFRA VKS 125 Mode D'emploi

Dear customer,
Thank you for purchasing an ALFRA product. Please read these operation instructions closely before using your
device for the first time and keep them for later reference.

Safety instructions

The knife is very sharp. Do not reach into the cutting area and do not touch the edge of the
knife.
The cutting area is to be kept clean. It is absolutely necessary that the scrap is removed from
the cutting area. Remove parts, e.g. chips, rejects with suitable and safe tools. Risk of injury!
The device must be completely mounted on a firm and tilt-proof basis before operating.
The mounting parts are not included. Please use suitable and rugged mounting parts
according to the basis.
For ideal cutting results and operation of the device the knife has always to be sharp.
If the knife is dull, it has to be exchanged.
The spring-loaded blade guard has to fold up promptly after the cutting procedure. If this
feature does not work the knife has to be secured or removed immediately to avoid injuries.
Before operating the device again the blade guard has to be repaired or exchanged.

Specified conditions of use

The VKS 125 is only to be used to cut plastic wiring ducts and covers up to a width of 125 mm and a wall thickness
up to 2,5 mm. It is only suitable for soft, non-reinforced plastics. For wiring ducts made out of rigid PVC and
halogen-free plastics only partly suitable. Proper use only!
9