ALFRA VKS 125 Mode D'emploi page 12

2. Hold the wiring duct only at the front and outside of the cutting area and the blade position. Do not reach
behind the wiring duct. For the desired cutting dimension connect the wiring duct to the length stopper
then slide it completely back against the counter support. The blade has to be placed between the bars.
Possibly the duct has to be moved back to the previous slot. If the exact dimension is desired, the according
bar can be broken out and it can be cut on its place.
3. To cut, pull the lever down. After the cutting, press the lever back up and carefully remove the cut duct
parts. For this perhaps the length stopper has to be loosened.
The blade guard has to fold up against the blade automatically after every cutting procedure.
If the cutting can be done only with great effort, the blade is dull or damaged. It has to be
exchanged.
12